EQP-110 Pierburg Fuel Pump Bench Tester

Additional information


Fuel pump tester for repair shops and the aftermarket for rapid testing of electric fuel pumps off the vehicle. With this instrument electric fuel pumps can be tested in a simple way for functioning and leaks regardless of the vehicle.

Pump units, feed pumps as well as in tank and in line pumps can be tested.

For trade, service and workshops.

The instrument is suitable for the following measurements:

  • Delivery rate (volume flow) for system pressures from 0.2–6.5 bar
  • Static pressure (for E1F pump series)
  • Holding pressure (leak test) (not for E1F pump series)
  • Power consumption

The following are integrated into the tester

  • Display unit
  • Voltmeter
  • Ampere meter
  • Manometer
  • Flowmeter

This OE quality product is made by Pierburg (Germany).

EQP-110 Pierburg Fuel Pump Bench Tester Demo


Length: 515mm
Width: 445mm
Height: 420mm
Weight: 2.3 kg (no fluid)

Voltage: 12 V
Current: 20 A
Internal fuses: 25 A
Filling amount: Approx. 9 litres or approximately half the height of the pan.
Power supply: 12V DC via vehicle battery or separate power supply. (Not included)


Tester, complete (without test fluid), connecting cable, accessory set and operating instructions.

  • Tester complete (Display unit and Lower section for test liquid)
  • Connection cable
  • Accessory kit consisting of:
    • Hexagon socket screws to lock the upper part of the instrument into position
    • 1 Screw connection M10 x 1; M12 x 1.5
    • 1 Cap nut M12 x 1.5
    • 1 Screw connection M12 x 1.0; 8 mm connection
    • 3 Conical nipples 10.2 x 14 x 1.2 mm
    • 3 Conical nipples 12.2 x 16 x 1.5 mm
    • 2 Reducer Ø 8 – 6 mm; plastic
    • 1 Fuel hose approx. 15 cm long
    • 1 Hollow-core screw M12 x 1.0
    • 1 Ring connection Ø 12 mm ; 8 mm connection
    • 2 Hose clips Ø 14
  • Operating instructions


This device may only be operated with suitable test fluid which is not included with the kit. The instrument may be operated only with test liquid in accordance with ISO 4113. Combustible fuels must not be used.

Refer safety datasheet supplied in operating instructions according to 91/155/EEC.

Refer to operating instructions for full details of operation.

Basic Test procedure

The fuel pump must be checked according to the test steps for the respective system pressure:

  • 0.2–1 bar,
  • 1.1–3 bar and
  • 3.1–6.5 bar.

Basic Test procedure for fuel pump tester see image to the right (excerpt from the operating instructions).

EQP-110 Pierburg Fuel Pump Bench Tester Instruction

Weight 2.3 kg
Dimensions 51.5 × 44.5 × 42 cm